No products in the cart.
Operating Voltage: 5V DCDetecting Range:200-10000 ppmRelative Humidity:<95% RHMQ6 - LPG Propane Gas Sensor Module
Using imported groove optical coupling sensor, width 5mm.It has the output state light, if output high level, the lights are off. if output low level, it on.If it covered, it will output high level; otherwise, its output low level.Good signal and waveform, with a strong driving ability for more than 15mA.Equipped with a fixed bolt hole, easy install.Use the LM393 wide voltage comparer.Speed Measuring Sensor Groove Coupler Module For Arduino
Type : Incremental Encoder.Cycles per revolution (CPR) : 20.Working voltage : 0 – 5V.Material : PCB + Brass.Mounting Nut Thread diameter: 6.6mmWeight : 10 gm.360 Degree Rotary Encoder Module
Output current: Iout=1.2A(average) / 3.2A (peak)Standby control to save powerCW/CCW/short break/stop motor control modesBuilt-in thermal shutdown circuit and a low voltage detecting circuitAll pins of the TB6612FNG broken out to 0.1 spaced pinsFiltering capacitors on both supply linesTB6612FNG Dual Motor Driver Module 1A for Arduino
Current Ratio: 5 A:5 mA
Rated Primary Current at 50/60 Hz: 5 A
Winding D.C. Resistance at 20 °C: 155 Ω
Maximum Primary Current at 50/60 Hz: 20 A
Transformer Turns Ratio: Np:Ns = 1000:1
ZMCT103C AC Current Sensor Module
Low-noise analog signal path.Device bandwidth is set via the new FILTER pin.5 µs output rise time in response to step input current.Small footprint, low-profile SOIC8 package.2.1 kV RMS minimum isolation voltage from pins 1-4 to pins 5-8ACS712 - 5A Range Current Sensor ModuleACS712 - 5A Range Current Sensor Module
The width of the optical coupling slot: 10mm
Single signal output.
The circuit board output switch!
The output valid signal is low.
Can be used for workpiece counts.
It can also be used for industry counting, motor speed testing.
Correlation Photoelectric Infrared Count Slot Sensor Module 10 mm
S49E hall sensorFeatures wide-range voltage comparator LM393Signal output indicatorAnalog / Digital outputLM393 Linear Hall Effect Sensor Module
Module: Non-isolated step-down module (BUCK)Input voltage: DC 4.75V-23VOutput voltage: DC 1.0V-17V (Adjustable, Output < Input)Rectification: Synchronous rectificationBuilt-in 160°C thermal shutdownOutput ripple: 30mV (no-load)Step Down Buck Converter Power Supply Module
Select at least 2 products
to compare