No products in the cart.
Showing all 7 results
- Dual channel stereo, high output power (3 w + 3 w power @ 5V and 4 ohms load)..
- Double panel wiring solves crosstalk.
- Super mini design allows it to be easily placed in a variety of digital products.
- 3W Output at 10% THD with a 4ΩLoad and 5V Power Supply.
- Filterless, Low Quiescent Current and Low EMI and Low Noise.
- Short Circuit Protection and Thermal Shutdown
- PAM8403 5V Two-channel Stereo Mini Class-D 3W+3W Audio Amplifier
Add to Wishlist
Add to Wishlist
-
Dual-Channel Stereo Output
-
Run-on 7V to 15V power Supply
-
32 Steps DC volume control has a +32dB to -75dB range.
-
40 pin QFN 6 x 6 mm package.
-
Much higher efficiency in terms of cost and performance than competitors’ ICs
-
PAM8610 Digital Stereo Class-D Amplifier Module 2x15W Output
Add to Wishlist
Add to Wishlist
-
Operating voltage: 2.5V-5.5V
-
Maximum output power: 3W x 2
-
PCB size is about: length 30mm width 22mm overall height after installed is about 16mm
-
Built with switch Potentiometer, can adjust the volume & control power switch freely!
-
Flexible assembly usage.
-
PAM8403 Mini 5V Audio Amplifier Board with Switch Potentiometer
Add to Wishlist
Add to Wishlist
-
Bluetooth 3.0 with audio signal decoding feature.
-
The output is directly compatible with the amplifier.
-
Very little weight and small size form factor make it easily fits into any application area.
-
Can be used to Design your own wireless music system
-
Low power consumption.
-
3.7v-4V voltage supply.
-
Bluetooth 3.0 Audio Receiver Module with Stereo Output
Add to Wishlist
Add to Wishlist
-
Dual channel stereo, high output power (3 w + 3 w power @ 5V and 4 ohms load)..
-
Double panel wiring solves crosstalk.
-
Super mini design allows it to be easily placed in a variety of digital products.
-
3W Output at 10% THD with a 4ΩLoad and 5V Power Supply.
-
Filterless, Low Quiescent Current and Low EMI and Low Noise.
-
Short Circuit Protection and Thermal Shutdown
-
5V Two-channel Stereo Mini Class-D 3W+3W Audio Amplifier
Add to Wishlist
Add to Wishlist
TDA2030A Audio Power Amplifier Module
-
On board TDA2030A Audio amplifier Board
-
Mono channel 18W Power amplifier circuit design
-
On board horn socket
-
On board 10 k adjustable resistance, can adjust the volume of the amplification
-
On board power indicator light
-
Chip has lead to the main pin, can directly input audio signal
-
Working voltage:6-12V
-
TDA2030A Audio Power Amplifier Module
Add to Wishlist
Add to Wishlist
LM386 Audio Amplifier Module
-
Onboard LM386 Chip.
-
200 multiplier benefits circuit design.
-
On-board speaker wiring Block.
-
On-board 10K variable resistor, you can adjust the volume of the enlarged.
-
Onboard power indicator.
-
LM386 Audio Amplifier Module
Add to Wishlist
Add to Wishlist
Recently Viewed Products
Dual Micro USB 3.7v to 5V 2A Power Bank DIY Charger
-
4-level LED lamp display power, not working state intelligent automatic shutdown;
-
The built-in lithium battery protection IC, over-current, overpressure, under-voltage protection;
-
Dual USB output ports.
-
Input requirements: 5V constant voltage power supply can do charge input power, the most matching charger for 5V 1A above
-
Compatible Batteries: 18650 batteries, cell phone batteries, flat-panel batteries, MP3 batteries, etc. 3.7v-4.2V polymer Lithium battery.
-
Dual Micro USB 3.7v to 5V 2A Power Bank DIY Charger
Add to Wishlist
Add to Wishlist
2.1×5.5mm Male Dc Power-plug Jack Connector
-
Type: Male DC Power Plug Jack Connector
-
Size: 2.1mm inner diameter, 5.5mm outer diameter
-
Polarity: The standard configuration for this type of connector is center-positive, which means the center pin is the positive (+) terminal, and the outer barrel is the negative (-) terminal.
-
Usage: It is used for providing power to a wide range of electronic devices, including cameras, routers, LED lighting, and various other consumer electronics.
-
2.1x5.5mm Male Dc Power-plug Jack Connector
Add to Wishlist
Add to Wishlist
5mm IR Transmitter Receiver Pair
-
This is the IR Transmitter and Receiver pair matched pair used in our IR proximity, White Line or Micro-mouse sensor.
-
It consists of 5 mm 940 nano-meter wave length high power IR LED.
-
Photo-diode having peak sensitivity at 940 nano-meter wavelength
-
5mm IR Transmitter Receiver Pair.
Add to Wishlist
Add to Wishlist
-
Motor KV: 1000
-
Max. Efficiency Current: 6-12A
-
No Load Current: 0.7A @10V
-
Current Capacity: 16A/60S
-
LiPO Batteries: 2S-3S
-
A2212 - 100KV BLDC Brushless Motor
Add to Wishlist
Add to Wishlist