15%

12-0-12 12V 2A Center Tapped Step Down Transformer

Input Voltage:230V AC
Output Voltage:12V, 12V or 0V
Output Current:2 Amp
Mounting:Vertical mount type
Winding:Copper

21%

12-0-12 12V 1A Center Tapped Step Down Transformer

Input Voltage:230V AC
Output Voltage:12V, 12V or 0V
Output Current:1 Amp
Mounting:Vertical mount type

24%

12-0-12 12V 500mA Center Tapped Step Down Transformer

Input Voltage:230V AC
Output Voltage:12V, 12V or 0V
Output Current:500mA
Mounting:Vertical mount type

22%

9-0-9 9V 500mA Center Tapped Step Down Transformer

Input Voltage: 230V AC
Output Voltage:9V, 9V or 0V
Output Current:500mA
Mounting:Vertical mount type

24%

6-0-6 6V 500mA Center Tapped Step Down Transformer

Input Voltage:230V AC
Output Voltage:6V, 6V or 0V
Output Current:500mA
Mounting:Vertical mount type

21%

XT90 Male/Female Connector with Housing – 1 Pair

Connector type: XT90 Mail-Female pair
Metal connector size: 4.5mm
Housing shape provides protection against shorting and reverse polarity
Can accept up to 8AWG wires
Able to sustain 90A+ continuous current.

56%

Pixhawk 2.4.8 Drone Flight Controller PX4 32 Bit Autopilot

Only 5 left in stock

Pixhawk 2.4.8 Drone Flight Controller PX4 32 Bit Autopilot

32bit STM32F427 Cortex M4 core with FPU
168MHz
256KB RAM
2 MB Flash

61%

MLX90614 ESF Non-Contact Human Body Infrared Temperature Measurement Module

Operating Voltage(V): 3- 5
Operating Current(mA): 2
Communication protocol: I2C
Power saving mode
Automotive grad
Small size, low cost

20%

HC-12 433 SI4463 Wireless Serial Module

Operating Frequency Range: 433.4—473.0MHz
Transmit Power Max: 20dBm
Power Supply Voltage: DC 3.2V ~5.5V
Long Communication Distance: About 1000 meters at the default setting

20%

ESP32 Node MCU Development Board with Wifi and Bluetooth (30 PIN)

To get started with the ESP32 Node MCU Development Board, follow these steps:
1. Download and install the CP2102 driver for your operating system.
2. Install the Arduino IDE and set up the ESP32 board support.
3. Connect the board to your computer using the USB cable.
4. Start creating and uploading your IoT projects!
Embrace the future of connected devices with the ESP32 Node MCU Development Board, and unleash your creativity in the world of IoT.

16%

16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi

Adjustable frequency PWM up to about 1.6 KHz
12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
Configurable push-pull or an open-drain output
The output enable pin to quickly disable all the outputs
Terminal block for power input
Reverse polarity protection on the terminal block input
Green power-good LED